Mounting Hardware Snowboard Binding Screws

About the Dakine Mounting Hardware

Pack of 8 14mm screws and washers by Dakine, perfect for mounting bindings onto snowboards.

All snowboards and snowboard bindings use the same diameter screw, which is size M6, with the same size thread. The only thing that varies is the length of the screw. It's the thickness of your binding baseplate which determines what length screw you need, and this varies from manufacturer to manufacturer and from binding to binding. The make and model of your snowboard are irrelevant because, thankfully, they all use the same inserts.

To measure the length of a screw, measure from the threaded tip up to the widest point on the circumference of the screw head.

Here's a quick guide to what screws tend to fit what bindings:

12mm: As used by many K2 and Ride Bindings. NB Our screws come with washers. K2 and Ride bindings tend not to use the washers so just chuck 'em away.

14 mm: This is the 'standard' size suitable for most makes of binding, including older models of Burton and 2007 Flow NXT bindings and all Flow bindings from 2008 onwards.

16mm: Most Burton bindings.

18mm: All Flow bindings pre-2008 - except Team and NXT.

If in doubt, use a shorter screw. If the screw is too long and you tighten it hard, it can punch a hole in the bottom of your board.

The advice we give on this page is only advice; we're not recommending you buy any particular length screws. If you order the wrong size screws, we can't accept responsibility for this, sorry. We do recommend you measure one of your old screws before ordering.